Product Reference Guide 6-79
RS-232 Software Flow Control
Enables/disables RS-232 Flow Control using XON/ XOFF characters. .
To set this feature:
1. Scan the SWITCH bar code.
2. Scan either the enable or disable bar code below. You’ll need to
cover any unused bar codes on this and the facing page to ensure
that the scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
RS-232 SOFTWARE FLOW CONTROL = DISABLE
RS-232 SOFTWARE FLOW CONTROL = ENABLE
NOTE
This item will be ignored when the feature, RS-232 NAK Character, is
enabled
To Next Page
Loading...
