Datalogic SG4-30-015-OO-E User Manual

SG4 BASE
26/74
3 MECHANICAL MOUNTING
The emitting (TX) and receiving (RX) units must be installed with the relevant sensitive surfaces facing each other.
The connectors must be positioned on the same side and the distance must be included within the operating range
of the model used (see cfr.TECHNICAL DATA page 49).
The two units shall be positioned so as to be aligned and parallel as much as possible.
The next step is the fine alignment, as shown in chapter ALIGNMENT PROCEDURE page 33.
Two types of brackets can be used to fix the two units:
Angled fixing brackets are supplied with all models (Fig 21 - page 26).
Adjustable supports for correcting unit inclination on the axes are available on request (see cfr.ACCESSORIES
page 54).
Fig 21 - Angle brackets
Rotating brackets (Fig 22 - page 26), available upon request, can be used as an alternative or together with
angled brackets.
For fixing with rotating bracket, refer to Fig 23 - page 27.
Fig 22 - Rotating brackets

Datalogic SG4-30-015-OO-E Specifications

General

Brand	Datalogic
Model	SG4-30-015-OO-E
Category	Security Sensors
Language	English