Datalogic Applications
110 Skorpio™ X4
3. Click OK to complete.
The added device will display on the left side of the console under
Available Device.
Connect to a Device via Network Using Scan2Pair
These steps assume you already have your network set up, and you
already have your printer set up. To connect a device to a Wi-Fi
access point and to DXU using the default settings, follow the steps
below:
1. Launch
DXU.
2. Click Scan2Deploy on the DXU main window.
3. Enter the SSID and Password for the Wi-Fi access point that your
device will use to connect to your network.
4. Click Print Preview.
NOTE
You will see the IP Address and port details displayed on
the DXU main window along with the model name, serial
number, and an illustration of the device.
NOTE
You can also directly connect the device to DXU using USB.
NOTE
In most cases you should be able to leave other fields with
their default values. You may, of course, change those
values as needed to work with your network setup.