Datamax H-4212X - Page 58

48 H-Class
Printer Options (continued)
Menu Item Details
GPIO PORT
Controls the optional Applicator Interface Card’s GPIO
function, where:
GPIO DEVICE
Sets the option to work with a specific device type,
where:
DISABLED
Disables the option.
APPLICATOR
Enables the following GPIO parameters for label
applicator functions:
• De-asserts Data Ready (DRDY) when the last label
starts printing to indicate completion;
• FEED allowed at any time; and,
• Does not de-assert DRDY upon PAUSE.
APPLICATOR 2
Enables the following GPIO parameters for label
applicator functions:
• Data Ready (DRDY) overlaps End of Print (EOP)
signal by about 1 msec. to indicate completion;
• DRDY signal end inhibits FEED; and,
• De-asserts DRDY upon PAUSE or FAULT.
BARCODE VERIFIER Enables the GPIO Port to work with a bar code verifier.
START OF PRINT
Selects the type of input signal required to initiate
Start of Print (SOP), where:
LOW PULSE Triggers printing with a low pulse.
HIGH PULSE Triggers printing with a high pulse.
ACTIVE LOW Triggers printing with a low signal.
ACTIVE HIGH
Triggers printing with a high signal.
EDGE Triggers printing with a signal edge transition.