Char Description Format
m Set metric flag, enter metric mode All references set to metric until reset
n Clear metric flag, return to inch mode
O Form edge offset (start of print
position)
Onnnn = 4 digits, in/100 or mm/10
o Cycle cutter
P Enter character dump mode
p Controlled pause
Q Clear all memory modules
q Clear module
qx = Module I.D. (Uppercase)
r Select reflective sensor Used for "black-strip" media sensing,
(e.g. continuous tags, butt-cut labels.
Stripe must be printed on back side of
media)
S Slew (feed) speed
Sx x = A -C (1.0 to 2.0 ips)
s Set up for one print buffer
Set for 1 dot buffer processing. Use for
full length dot buffer processing.
T Printhead dot pattern test label
t Test RAM memory module
(Must be in Test Mode)
a bbbK module good
bbb = 256 or 512, for size of module
U Label format field replacement
V Software switch settings Vn n = 4-Label Present, 2-Internal
Batch, 1-Cutter Enable
v Firmware version information Sends version string to host
W Request memory module information Wx x = F-font, G-graphic, L-label
w Test FLASH module memory Takes about 90 seconds
x Delete module file
xMFname M=Module I.D, F=file type
X Set default module bank
Xa a - A = Memory Module A
Y Output sensor values Dumps sensor values status to RS-232
port
y Select font symbol set (optional
scalable fonts only)
y S xx
y = ASCII (0x79)
S = ASCII (0x54)
xx = symbol selection
z Pack module
Z Print internal information and dot
pattern
Zx x= Module I.D
Table 2-3 System-Level Commands (concluded)
To Next Page
Loading...
Need help?
General