62 S-Class
Ticket Stock Requirements (continued)
Dimension
Description
[3]
Minimum Maximum Layout
A Ticket Width 2.0 3.25
B Reflective Mark Width
[6]
.50
3.25
C Reflective Mark Length
[4]
.125 –
D Distance between Reflective Marks
[4]
1.0 –
E Ticket Length
[4]
1.0 –
F Quiet Zone Width
[5]
.40 3.25
A
B
F
E
C
D
3
Units of measure are given in inches, and all dimensions are referenced in the direction of ticket travel through the printer.
4
The maximum allowable length of the combined ticket and mark measurement cannot exceed 99.99 inches.
5
This is an area free of reflective printing (excluding the reflective marks) that runs the entire length of the ticket.
6
Standard Media Sensor: The center of this mark must fall between .235 and 3.03 inches from the ticket edge, while allowing an adequate Quiet
Zone within that area.
Print Side Media Sensor: The center of the mark must fall between .250 and .750 of an inch from the ticket edge, while allowing an adequate
Quiet Zone within that area.
To Next Page
Loading...
