78
The two buttons turn solid white a few seconds after displaying the operation mode.
Switching operation modes
Follow the steps below to switch to the next operation mode:
First make sure the stream and record functions are in idle state, i.e. STREAM and RECORD
buttons are solid white.
Simultaneously press and hold the RECORD and STREAM buttons for more than 3 seconds but
less than 10 seconds.
As the operation mode switches, both the RECORD and STREAM buttons turn from solid red,
then blinking red and finally to solid white.
When the RECORD and STREAM buttons turn solid white, it indicates that the NVS-31 has
been switched to the next operation mode successfully.
Note: The order of the operation mode change is Stream & Record Stream Only Record Only
Checking the next operation mode
Follow the steps below to check the operation mode next to the NVS-31’s current operation mode
before switching:
First make sure the stream and record functions are in idle state, i.e. STREAM and RECORD
buttons are solid white.
Simultaneously press and hold the RECORD and STREAM buttons for more than 1 second but
less than 3 seconds.
The button LED should behave according to the device’s next operation mode. The LED
behaviors are summarized in the table below:
Solid white RECORD button
Solid white STREAM button
The two buttons turn solid white a few seconds after displaying the operation mode.
Note: The order of the operation mode change is Stream & Record Stream Only Record Only
6.5 Restoring Factory Defaults
Follow the steps below to restore the NVS-31’s factory defaults.
Two Button Model
The RECORD and STREAM buttons are either solid white and solid red, which means the
factory defaults can be restored regardless of the state of the device.
Press and hold the RECORD and STREAM buttons simultaneously for more than 10 seconds.
While the NVS-31’s factory defaults are being restored, the RECORD and STREAM buttons turn
from solid red, then blinking red and finally to solid white.
When the RECORD and STREAM buttons turn solid white, it indicates that the NVS-31’s factory
defaults have been successfully restored.
To Next Page
Loading...
Need help?
General
