24
Chapter 6 Basic Setup
Before using the TPC-700/TPC-700P to control other devices, please
make sure that the basic setup of the TPC-700/TPC-700P is done. This
chapter will make the SE-3200 HD 12-Channel Digital Video Switcher as
an example for explaining how to set the basic setup between the TPC-
700/TPC-700P and the SE-3200. Please set the basic setup of the TPC-
700/TPC-700P according to following steps.
6.1 Connect by Static IP Address
1. Please use an RJ-45 Ethernet cable to connect from the Ethernet
interface on the rear panel of the SE-3200 to the DVIP RJ-45 Ethernet
interface on the right side of the TPC-700/TPC-700P.
6.2 Connect by DHCP
1. Please use an RJ-45 Ethernet cable to connect from the Ethernet
interface on the rear panel of the SE-3200 main unit to the RJ-45
Ethernet interface on your router.
2. Please use an RJ-45 Ethernet cable to connect from the DVIP RJ-45
Ethernet interface on the right side of the TPC-700/TPC-700P to the RJ-
45 Ethernet interface of the same router.
To Next Page
