58
After that, users can select their desired language. If the “Save” button
is pressed, it will go back to previous page after the setting is saved. If
the “Cancel” button is pressed, it will go back to previous page directly.
2. Connect: Press this button for entering the “Connect” interface.
Please press the “Scan” button for scanning the connected SE-3200.
After the SE-3200 is found, Please click the “IP Select” drop-down menu
to select the IP address of the connected device.
After that, please click the “Connect” button to connect the TPC-
700/TPC-700P and the SE-3200. If the “Disconnect” button is pressed
during the TPC-700/TPC-700P and the SE-3200 are connected, the
connection will be cancelled. If the “Cancel” button is pressed, it will go
back to the “Setup” interface.
To Next Page
Loading...
Need help?
General
