118
Chapter 14 Interface Introduction of the TPC-
700/TPC-700P Built-in TVS-2000A App
Please pay attention that you need to finish the setup between the
TVS-2000A main unit & TPC-700/TPC-700P. Moreover, you need to set
the TVS-2000A PC version shortcut keys in advance. After that, you can
use the TPC-700/TPC-700P built-in TVS-2000A app to control your TVS-
2000A PC version. For the setup of the TPC-700/TPC-700P & TVS-2000A
and the way to set the TVS-2000A PC version shortcut keys, please
refer to “DownloadsOthers” from Datavideo official
website’s(www.datavideo.com) TPC-700/TPC-700P product pages.
After the setup is finished, please press the icon of the TVS-2000A app
and then you can see the main interface of the TVS-2000A app which is
shown in the following diagram. For the introduction of the TVS-2000A
app interface, please refer to the following section.
14.1 Home
1. Button 1: The Button 1 allows you to show the far view of
the front camera angle to the PGM screen of the TVS-2000A. The
Button 1 is corresponding to the shortcut key “F1” in the TVS-2000A PC
version software.
2. Button 2: The Button 2 allows you to show the near view of
the front camera angle to the PGM screen of the TVS-2000A. The
To Next Page
Loading...
Need help?
General
