Datavideo TPC-700P User Manual

75
 Lumakey ON/OFF toggle switch：Click this toggle switch to turn on or
turn off the Lumakey function.
 KEY MODE: There are two Modes including Black and White Modes.
Click this button once to switch between the Black and White. Select
“Black” if the foreground is shot against a black background and “White” if
the foreground is shot against a white background.
 LAYER SWAP: There are two modes including “Front” and “Back”. Click
this button once to switch between “Front” and “Back”. Enable “Layer
Swap” to place the Chromakey layer on top of the AUX Lumakey layer
and vice versa.
 “Cut Off”: The default “Cut Off” value is 0. Increase this value gradually
until either of the black and white backgrounds of the AUX source is
100% removed. For a black background, set Cut Off to 10-20% of its
maximum value. For a white background, set Cut Off to 80-90% of its
maximum value. You can use the slider or the left and right arrow
buttons to adjust the “Cut Off” option.
 Swap Time: Swap time sets the transition time during layer swap. For
example, if the swap time is set to 20, multiply this number by 0.1 to
derive the transition time of 2 seconds. You can use the slider or the left
and right arrow buttons to adjust the “Swap Time” option.

Datavideo TPC-700P Specifications

General

Brand	Datavideo
Model	TPC-700P
Category	Controller
Language	English