EasyManuals Logo

DCS 9 Series User Guide

DCS 9 Series
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
9
SAFETY AND WARNINGS
Fire
z
Have an ABC rated fire extinguisher accessible – never attempt to extinguish a grease
fire with water or other liquids.
z
Never leave the product unattended when in use.
z
Always remove dust cover and open hood before lighting. Do not replace cover during
cooking or before appliance has cooled.
z
Do not use a flame to check for gas leaks.
z
Do not smoke while leak testing.
z
Do not attempt to disconnect any gas connections while your appliance is in use, or the
gas supply is on.
z
Never connect an unregulated gas line to the appliance.
Electrical Hazards
z
Do not operate with a damaged cord or plug, after the appliance malfunctions or after
the appliance has been damaged in any manner. Contact the manufacturer for repair.
z
Keep any electrical supply cord, the rotisserie motor cord and the fuel supply
hose away from the heated areas of the grill, sharp edges and water (pools,
fountains, puddles).
z
When connecting, first connect plug into the appliance and then plug appliance
into the outlet.
z
Do not let the cord hang over the edge of a table or touch hot surfaces.
Installation Warnings
z
The installation of this appliance must conform with local codes or, in the absence of
local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54. Installation in
Canada must be in accordance with Natural Gas and Propane Installation Code, CSA
B149.1, and/or Propane Storage and Handling Code, B149.2 and local codes.
z
This appliance must be electrically grounded in accordance with local codes, or in the
absence of local codes, with NFPA 70 or the Canadian Electrical Code, Part I.
z
This appliance must only be used outdoors and must not be used in a building, garage
or any other enclosed area.
z
An appliance is considered to be outdoors if installed with shelter no more inclusive
than within a partial enclosure that includes an overhead cover and three sidewalls, as
long as 30% or more of the horizontal periphery of the enclosure is permanently open.
All openings must be permanently open; sliding doors, garage doors, windows, or
screened openings are not considered as permanent openings.
z
If installed under overhead combustible construction, the appliance must be installed in
conjunction with a suitable UL 710- or ULC S646-approved heavy duty vent hood only.
The vent hood must be placed in operation when the appliance is in use.
z
All gas connections, installations and leak testing should be made by a
qualified technician.
z
Installation must comply with clearances to combustible materials as noted in the
Planning Guide.
z
Do not attempt to remove, repair, or replace the regulator/hose assembly. This must be
done by a qualified licensed technician only. The grill system arrives leak tested.
z
If the connections are not perfectly sealed, you can have a small leak and therefore
a faint gas smell. Some leaks can only be found with the burner control in the “ON”
position - this must be done by a qualified technician.
z
Keep the ventilation openings of the cylinder enclosure free and clear from debris.
z
This outdoor cooking gas appliance is not intended to be installed in or on recreational
vehicles, trailers and/or boats.

Other manuals for DCS 9 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DCS 9 Series and is the answer not in the manual?

DCS 9 Series Specifications

General IconGeneral
BrandDCS
Model9 Series
CategoryGrill
LanguageEnglish

Related product manuals