DeDietrich MCA 45 - Bleeding the Heating System

6.4 Bleeding the heating system
It is essential that you bleed any air in the calorifier, the conduits or
the taps to prevent the annoying noises likely to be produced during
heating or when tapping water. To do this, proceed as follows:
1. Open the valves on all radiators connected to the heating system.
2. Set the heating set point to as high a temperature as possible.
3. Wait until the radiators are hot.
4. Switch the boiler off.
5. Wait around 10 minutes until the radiators are cold.
6. Bleed the radiators. Start with the lower floors.
1
2
3
4
T000181-B
T000184-A
T000185-A
T000854-A
3
1
4
5
2
MCA 45 - 65 - 90 - 115 6. Checking and maintenance
06/09/2010 - 300024828-001-A
38