Deif GPC-3 - View Menu; View Menu Navigation

3.2.2 View menu
The view menus (V1, V2 and V3) are the most commonly used menus of the unit.
Paralleling and Protection Unit
multi-line PPU
G 0.001 PF 0%P
SETUP V3 V2 V1
DG BLOCKED FOR START
G L1 0.00Hz 0V
1
2
3
4
1. First display line: Operational status or measurements
2. Second display line: Measurements relating to operational status
3. Third display line: Measurements relating to operational status
4. Fourth display line: Selection of setup and view menus
In the view menus, various measured values are on the display.
3.2.3 View menu navigation
Views and setup are all selected by moving the cursor in the fourth display line (please notice the
underscore
of V3 in the drawing above – this indicates the position of the cursor).
The cursor is moved by means of the
and push-buttons on the right side of the display.
View window 1 (V1)
For detailed information about configuration, please see the Designer’s Reference Handbook.
V1 contains up to 20 different windows that can be selected using the and push-buttons.
View window 2 (V2)
V2 is a copy of V1 and contains up to 20 different windows that can be selected using the
and
push-buttons.
View window 3 (V3)
The V3 display changes with the running mode:
The first display line indicates the status of the unit.
The second and third display lines display power consumption in kW or percentage. This is changed by
pressing the or push-button.
ML-2 operators manual 4189340579 UK
Menu systems and structure
DEIF A/S Page 15 of 29