The third column describes the function of the parameter.
The fourth column indicates the minimum/maximum set point available for this setting.
The fifth column indicates the default set point of the unit from the factory. When it is necessary, additional
information will be supplied below the table in order to make the individual parameter descriptions as informa-
tive as possible.
6.4 Setup
At this point of the process, the specific parameter description will have been located. Now, follow the menu
structure presented earlier in this manual to set up the individual parameters. (In this overall example, we
have chosen to change the set point of the parameter 1000 G -P>).
Step 1: Enter the setup menu via SETUP in the fourth display line in the entry window.
Step 2: Enter the protection menu via PROT in the fourth display line in the setup menu.
Step 3:
Use the and push-buttons to locate the selected parameter.
Step 4: Enter the set point menu via SP in the fourth display line.
Step 5: Enter password to change the set point.
Step 6:
Use the and push-buttons to increase/decrease the set point setting.
Step 7: Move the “underscore” to save and press SEL; the new set point setting has now been saved.
ML-2 operators manual 4189340579 UK Parameter setup
DEIF A/S Page 29 of 29
To Previous Page
Loading...
