9. Features
9.1 About Features
The controller includes features to save power and monitor the genset load.
9.2 Auto config exit mode
In this mode, the controller automatically exits the Configuration mode when there is no user interaction for the preset Auto config
exit mode delay time.
The controller saves all the configuration parameter changes and exits Configuration mode.
9.3 Load histogram
Load histogram displays the engine running hours in load groups. This mode helps the user to monitor the time of a genset runs with
a specific percentage of load.
The load percentage is calculated based on following parameters:
• Generator rating
• CT ratio
USER MANUAL 4189341227A UK Page 55 of 86
To Next Page
Loading...
