Deep sleep mode
Deep sleep mode is a useful feature to extend the battery lifetime. This is done by suspending normal functions of the controller, and
place the it in the lowest power consumption state. The controller maintains the status and alarms it had before Deep sleep mode.
When the controller wakes up, normal operations are resumed automatically.
The controller goes to Deep sleep mode when there is no user interaction for the preset Deep sleep mode delay. The controller does
not go to Deep sleep mode under the following conditions:
• In Auto (Site, AMF, Cyclic, Remote start/stop and Exercise) modes
• Mains monitoring is enabled, and mains contactor configured as output
• Modbus communication is enabled
To wake the controller from Deep sleep mode, press:
• Stop/Config button
• Start
button
• Mode selection button
• Acknowledge button
7.2 Manual mode
Module Operation in Manual Mode
DG OFF
Warm up
DG ON
Engine
cooling
Start button
Warm up delay expired
Stop button
Engine
cooling
USER MANUAL 4189341227A UK Page 50 of 86
To Next Page
Loading...
