Part Number: 9291481 05/18 5
DANGER
Installation must comply with all applicable fire and
health codes in your jurisdiction.
DANGER
Use appropriate safety equipment during installation and
servicing
DANGER
Check all wiring connections, including factory terminals,
before operation. Connections can become loose during
shipment and installation.
DANGER
Copper wire suitable for at least 167°F (75°C) must be
used for power connections.
n
Warning
Remove all removable panels before lifting and installing.
n
Warning
To avoid instability the installation area must be capable
of supporting the combined weight of the equipment
and product. Additionally the equipment must be level
side to side and front to back.
n
Warning
This equipment is intended for indoor use only. Do not
install or operate this equipment in outdoor areas.
n
Warning
This appliance must be grounded and all field wiring must
conform to all applicable local and national codes. Refer
to rating plate for proper voltage. It is the responsibility of
the end user to provide the disconnect means to satisfy
the authority having jurisdiction.
n
Warning
If a refrigerated base does not have a condensate
evaporator supplied, you must connect the condensate
line to a suitable drain. Otherwise, water will collect on
the floor, causing a potentially hazardous situation.
n
Warning
Moisture collecting from improper drainage can create a
slippery surface on the floor and a hazard to employees.
It is the owner’s responsibility to provide a container or
outlet for drainage.
,
Caution
When adding any item verify the location of the
refrigeration lines on wrapped rail units. A refrigeration
leak in a rail may be irreparable or extremely difficult and
costly to repair.
,
Caution
Do not position the air intake vent near steam or heat
exhaust of another appliance.
Section 2
Installation
To Next Page
Loading...
Need help?
General
