User’sGuide
deliberant Page17
Site Survey – information about other wireless networks in the local area.
Delayed reboot – setup delayed reboot for APC unit.
Ping – perform ping command.
Traceroute – perform graphical traceroute command.
Spectrum analyzer – check the signal strength on available channels.
ApplingandSavingConfigurationChanges
There are three general buttons located on the right top corner of the WEB GUI allowing managing
device configuration:
Apply – if pressed new configuration settings are applied instantly. It will take few seconds and
the device will be running with new settings. It should be noted that pressing Apply button
settings are not written to the permanent memory. Therefore, if the device is rebooted it will
start with old configuration settings.
Discard – if pressed parameter changes are discarded. It should be noted that if Apply or
Save&Apply is pressed it is not possible to discard changes.
Save&Apply – if pressed new configuration settings are applied instantly and written to the
permanent memory.
It is not required to press Apply or Save&Apply in every Web GUI tab. The device
remembers all changes made in every tab and after action button is used, all changes will
be applied.
To Next Page
Loading...
