Figure 81. Removing the optional IDSDM module
NOTE: There are two dip switches on the IDSDM module for write-protection.
Next steps
Install the optional IDSDM/vFlash card.
Installing optional IDSDM or vFlash card
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash connector, see the Jumpers and connectors section.
Align the IDSDM/vFlash card with the connector on the system board.
Push the IDSDM/vFlash card until it is firmly seated on the system board.
126 Installing and removing system components
To Next Page
Loading...
