USB module
Removing the USB module
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Follow the procedure listed in Before working inside your system.
Remove the backplane cover.
Remove the air shroud.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route these
cables properly when you replace them to prevent them from being pinched or crimped.
NOTE: The procedure to remove the USB 3.0 and USB 2.0 modules is similar.
Steps
Disconnect the USB cable from the USB connector on the system board. For more information, see the System board jumpers and
connecters section.
Using Phillips #1 screwdriver, remove the screws on the USB module.
Slide the module out of the system until it is free of the USB module slot on the front panel.
Figure 111. Removing the USB module
Next steps
Install the USB module.
Installing the USB module
Prerequisites
Follow the safety guidelines listed in Safety instructions.
NOTE: The procedure to install the USB 3.0 and USB 2.0 modules is similar.
148 Installing and removing system components
To Next Page
Loading...
