Figure 106. Installing the SAS expander card
Next steps
Connect the SAS cables to the SAS expander card.
Install the backplane cover.
Install the cooling fan assembly.
Install the cooling shroud.
Follow the procedure listed in After working inside your system.
Rear drive cage
Removing the rear drive cage
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Follow the procedure listed in Before working inside your system.
Remove all the drives.
Disconnect all the cables from the rear drive backplane.
Steps
Using Phillips #2 screwdriver, loosen the screws that secure the drive cage to the system.
Pull and hold the screws to lift the drive cage away from the system.
Installing and removing system components 145
To Next Page
Loading...
