Figure 127. Installing the cable cover
Next steps
Install the air shroud.
If applicable, install the cooling fan #1.
Follow the procedure listed in After working inside your system.
Removing the right control panel
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Follow the procedure listed in Before working inside your system.
For ease of removal of the right control panel, remove the cooling fan #8 to access the cable latch.
Steps
Lift the cable latch and disconnect the control panel cable from the connector on the system board.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. You must route
the cables properly when you replace them to prevent the cables from being pinched or crimped.
Using a Phillips #1 screwdriver, remove the screws that secure the cable cover to the system.
Figure 128. Removing the cable cover
Using a Phillips #1 screwdriver, remove the screw that secures the control panel to the system.
Installing and removing system components 165
To Next Page
Loading...
