Follow the procedure listed in After working inside your system.
Integrated storage controller card
Removing the integrated storage controller card
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Follow the procedure listed in After working inside your system.
Remove the air shroud.
Steps
Using Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the connector on the system
board.
Lift the integrated storage controller cable to disconnect it from the connector on the system board.
Figure 87. Removing the integrated storage controller cable
Lift one end of the card and angle it to disengage the card from the card holder on the system board.
Lift the card out of the system.
Installing and removing system components 131
To Next Page
Loading...
