Figure 96. Removing the 2.5 inch drive rear backplane
Figure 97. 2 X 2.5 rear drive backplane
1. power connector 2. backplane signal connector
3. SAS cable connector 4. NVMe cable connector
Next steps
Install the 2.5 inch drive rear backplane.
Installing the 2.5 inch drive rear backplane
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
Use the hooks on the rear drive cage as guides to align the drive backplane.
Lower the backplane into the system until it is firmly seated.
Using Phillips #2 screwdriver, replace the screws to secure the backplane to the rear drive cage.
Installing and removing system components 137
To Next Page
Loading...
