Figure 107. Removing the rear drive cage
Next steps
Install the rear drive cage.
Installing the rear drive cage
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
Align the screws on the drive cage with the screw holes on the system chassis.
Lower the drive cage into the system until it is firmly seated and the screws locks into place.
Using Phillips #2 screwdriver, tighten the screws.
Figure 108. Installing the rear drive cage
Next steps
Reconnect all the disconnected cables to the rear drive backplane.
Install all the drives.
146 Installing and removing system components
To Next Page
Loading...
