Figure 23. Removing the expansion riser 2B
Next steps
Install the expansion card riser.
Installing an expansion card riser
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Before installing the expansion card riser 2A, install an expansion card into the riser, if applicable.
Steps
If removed, install the expansion cards into the expansion card riser.
Holding the touch points, align the expansion card riser with the connector and the riser guide pin on the system board.
NOTE: While installing riser 1B, press the tabs and hold the touch point to align the expansion card riser and the riser
guide pin on the system board.
Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector.
40 Technical specifications
To Next Page
Loading...
