Figure 82. Installing optional IDSDM module
Next steps
Install the MicroSD cards.
NOTE: Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during
removal.
Follow the procedure listed in After working inside your system.
Optional IDSDM or vFlash module
NOTE: The write-protect switch is on the IDSDM or vFlash module.
Removing the MicroSD card
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Follow the procedure listed in Before working inside your system.
Steps
Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate IDSDM/
vFlash module, see the System board jumpers and connectors section.
Hold the MicroSD card and remove it from the slot.
NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal.
Installing and removing system components 127
To Next Page
Loading...
