Figure 125. Removing left control panel
Holding the control panel by its sides, remove the control panel away from the system.
Next steps
Install the left control panel.
Installing the left control panel
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
Route the control panel cable through the side wall of the system.
Align the left control panel assembly with the control panel slot on the system and place the assembly in the slot on the system.
Connect the control panel cable to the system board connector and secure it using cable latch.
Using a Phillips #1 screwdriver, install the screws that secure the control panel to the system.
Figure 126. Installing the left control panel
Using Phillips #1 screwdriver, install the screws that secure the cable cover to the system.
164 Installing and removing system components
To Next Page
Loading...
