Option Description
Maximum data rate indicates that the BIOS runs the communication links at the maximum frequency supported by
the processors. You can also select specific frequencies that the processors support, which can vary.
For best performance, you should select Maximum data rate. Any reduction in the communication link frequency
affects the performance of non-local memory accesses and cache coherency traffic. In addition, it can slow
access to non-local I/O devices from a particular processor.
However, if power saving considerations outweigh performance, you might want to reduce the frequency of the
processor communication links. If you do this, you should localize memory and I/O accesses to the nearest NUMA
node to minimize the impact to system performance.
Virtualization
Technology
Enables or disables the virtualization technology for the processor. This option is set to Enabled by default.
Adjacent Cache
Line Prefetch
Optimizes the system for applications that need high utilization of sequential memory access. This option is set to
Enabled by default. You can disable this option for applications that need high utilization of random memory
access.
Hardware
Prefetcher
Enables or disables the hardware prefetcher. This option is set to Enabled by default.
Software
Prefetcher
Enables or disables the software prefetcher. This option is set to Enabled by default.
DCU Streamer
Prefetcher
Enables or disables the Data Cache Unit (DCU) streamer prefetcher. This option is set to Enabled by default.
DCU IP Prefetcher Enables or disables the Data Cache Unit (DCU) IP prefetcher. This option is set to Enabled by default.
Sub NUMA Cluster Enables or disables the Sub NUMA Cluster. This option is set to Disabled by default.
UPI Prefetch Enables you to get the memory read started early on DDR bus. The Ultra Path Interconnect (UPI) Rx path will
spawn the speculative memory read to Integrated Memory Controller (iMC) directly. This option is set to Enabled
by default.
Logical Processor
Idling
Enables you to improve the energy efficiency of a system. It uses the operating system core parking algorithm and
parks some of the logical processors in the system which in turn allows the corresponding processor cores to
transition into a lower power idle state. This option can only be enabled if the operating system supports it. It is set
to Disabled by default.
Configurable TDP Enables you to configure the TDP level. The available options are Nominal, Level 1, and Level 2. This option is set
to Nominal by default.
NOTE: This option is only available on certain stock keeping units (SKUs) of the processors.
SST-Performance
Profile
Enables you to reconfigure the processor using Speed Select Technology.
x2APIC Mode Enables or disables the x2APIC mode. This option is set to Disabled by default.
Dell Controlled
Turbo
Controls the turbo engagement. Enable this option only when System Profile is set to Disabled.
NOTE: Depending on the number of installed processors, there might be up to two processor
listings.
Dell AVX Scaling
Technology
Enables you to configure the Dell AVX scaling technology. This option is set to 0 by default.
Number of Cores
per Processor
Controls the number of enabled cores in each processor. This option is set to All by default.
Processor Core
Speed
Specifies the maximum core frequency of the processor.
Process Bus
Speed
Displays the bus speed of the processor.
Processor n
NOTE: Depending on the number of processors, there might be up to two processors listed.
The following settings are displayed for each processor installed in the system:
64 Pre-operating system management applications
To Next Page
Loading...
