Steps
1. To set up the mail server, enter:
# config set mailserver mail.datadomain.com
The Mail (SMTP) server is: mail.datadomain.com
2. To set up the system location, enter:
# config set location "Dallas Regional Data Center Lab,
5000 Apple Drive Suite #130, Dallas, Tx"
The System Location is: Dallas Regional Data Center Lab,
5000 Apple Drive Suite #130, Dallas, Tx
3. To add one or more time servers, enter:
# ntp add timeserver 192.168.101.1
Remote Time Servers: 192.168.10.1
4. To enable the NTP daemon, enter:
# ntp enable
NTP enabled.
5. To change the system time zone, enter:
NOTE: This requires a system reboot.
# config set timezone US/Central
The Timezone name is: US/Central
*** You made a change to the timezone setting. To fully effect this change
*** (in currently running processes), you need to reboot the machine.
6. Reboot the system for the time zone change to take effect:
# system reboot
The 'system reboot' command reboots the system. File access is interrupted during the
reboot.
Are you sure? (yes|no|?) [no]: yes
ok, proceeding.
The system is going down for reboot.
7. After the system completes the reboot, login again as sysadmin using the serial number as a password. Press Ctrl-C to
get through the EULA, sysadmin password prompt, and config setup wizard.
8. Generate an autosupport sent to yourself to use as ACG input:
# autosupport send your.email@emc.com
OK: Message sent.
Configuring the system with the configuration wizard
The protection system provides two wizards: a DD System Manager configuration wizard and a Command Line Interface
(CLI) configuration wizard. The configuration wizards guide you through a simplified configuration of your system to get your
protection system operating quickly.
About this task
After you complete the basic configuration with a wizard, you can use additional configuration controls in DD System Manager
and the CLI to further configure your system.
NOTE:
The following procedure describes how to start and run the DD System Manager configuration wizard after the
initial configuration of your protection system. For instructions on running the configuration wizards at system startup, see
the Installation Guide for your system model.
NOTE: To configure your system for HA, use the CLI Configuration Wizard. For more information, see the Installation Guide
for the HA-capable system.
Configure System for Use 81
To Next Page
Loading...
