Installing Drives in the External Bays 8-3
Figure 8-2. Removing a Plastic Insert
To replace a front-panel insert, position the insert over
the bay opening from the inside of the front bezel and
carefully press the insert into place. A tab on each side of
the insert snaps into a corresponding latch on the inside
of the front bezel.
Removing Metal Inserts
To remove the metal insert for a drive bay you intend to
use, first remove the front bezel as instructed in “Remov-
ing the Front Bezel” in Chapter 6. Next, remove the
retaining screw at the right end of the metal insert (see
Figure 8-3), and then pivot the metal insert out and slide
it to the right.
Figure 8-3. Removing a Metal Insert
C
onnecting the Drive
This section describes the power input connectors and
interface connectors on the back of most drives.
Figure 8-4 shows the 4-pin power input connector, where
you connect a direct current (DC) power cable from the
power supply. The power connectors are keyed to avoid
incorrect insertion; do not force two connectors together if
they do not fit properly.
metal insert
retaining
screw
To Next Page
Loading...
