Using the System Setup Program 4-17
R
esponding to Error Messages
If an error message appears on your monitor screen while
the system is booting, make a note of the message. Then,
before entering the System Setup program, refer to
Appendix F, “Beep Codes and System Messages,” for an
explanation of the message and suggestions for correct-
ing any errors. (An exception to this routine: It is normal
to receive an error message the first time you boot your
system after installing a memory upgrade. In that situa-
tion, you do not need to refer to Appendix F. Instead,
follow the instructions in “Performing a Memory
Upgrade” in Chapter 7.)
If you are given the option of pressing either <F1> to
continue or <F2> to run the System Setup program, press
the <F2> key.
To Next Page
Loading...
