Hardware Configuration Features B-3
Table B-1. System Board Jumpers
Jumper Setting Default Description
CARDBIOS Default System boots normally.
System boots from a BIOS expansion card. Used for troubleshooting.
VGA Default The built-in video subsystem is enabled.
The built-in video subsystem is disabled.
EISA Default The EISA Configuration Utility settings are retained at system boot.
The EISA Configuration Utility settings are cleared at next system boot. (If
the EISA Configuration Utility becomes corrupted to the point where the
system will not boot, install the jumper and boot the system. Remove the
jumper before restoring the EISA configuration information.)
PASSWD Default Boot password features are enabled.
Boot password features are disabled.
266MHZ Jumpered when the microprocessor’s internal operating frequency is
266 MHz.
Unjumpered when the microprocessor’s internal operating frequency is
233 MHz.
233MHZ Jumpered when the microprocessor’s internal operating frequency is
233 MHz.
Unjumpered when the microprocessor’s internal operating frequency is
266 MHz.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.
jumpered
unjumpered
To Next Page
Loading...
