Using the System Setup Program 4-7
A
dvanced Menu Categories
To access the Advanced menu (see Figure 4-3), use the
arrow keys to highlight Advanced. This section explains
in detail each of the System Setup categories in the
Advanced menu.
The Advanced menu allows you to set the COM and LPT
addresses, set the LPT mode, enable or disable the
on-board diskette controller, enable the PS/2 mouse, and
enable or disable the built-in SCSI controller. The
Advanced menu also lets you control the PCI scan
sequence. The PCI scan sequence determines which type
of PCI device is scanned first: built-in PCI drives or PCI
devices installed in PCI expansion slots.
Figure 4-3. Advanced Menu of the System Setup Program
Serial Port 1: [Auto]
Serial Port 2: [Auto]
Parallel Port: [378, IRQ7]
Parallel Mode: [Output only]
Diskette Controller: [Enabled]
Onboard SCSI: [Enabled]
PCI Scan Sequence: [Slot devices first]
Use MP Specification [1.4]
PS/2 Mouse: [Enabled]
Item-Specific Help
BIOS Version: A
XX
Main Advanced Security Exit
Configures the system’s
built-in serial port.
configuration options and system data
title box
help
key functions
F1 Help Select Item -/+ Change Values F9 Setup Defaults
ESC Exit Select Menu Enter Select Submenu F10 Previous Values
Dell System PowerEdge 2200 Setup
To Next Page
Loading...
