4
Safety instructions
Safety instructions
Use the following safety guidelines to protect your monitor from potential damage and to ensure your personal safety. Unless
otherwise noted, each procedure included in this document assumes that you have read the safety information that is shipped with
your monitor.
NOTE: Before using the monitor, read the safety information that is shipped with your monitor and is printed on the product.
Keep the documentation at a secure location for future reference.
WARNING: Use of controls, adjustments or procedures other than those specified in this documentation may result in
exposure to shock, electrical hazards and/or mechanical hazards.
CAUTION: The possible long-term effect of listening to audio at high volume through the headphones (on monitor that
support it) may cause damage to your hearing ability.
• Place the monitor on a solid surface and handle it carefully.
• The screen is fragile and can be damaged if dropped or hit with a sharp object.
• Ensure that your monitor is electrically rated to operate with the AC power available in your location.
• Keep the monitor at room temperature. Excessive cold or hot conditions can have an adverse effect on the liquid crystal of
the display.
• Connect the power cable from the monitor to a wall outlet that is near and accessible.
• Do not place and use the monitor on a wet surface or near water.
• Do not subject the monitor to severe vibration or high impact conditions. For example, do not place the monitor inside a car
trunk.
• Unplug the monitor when it is going to be left unused for an extended period.
• To avoid electric shock, do not attempt to remove any cover or touch the inside of the monitor.
• Read these instructions carefully. Keep this document for future reference. Follow all warnings and instructions marked on the
product.
• Certain monitors can be wall mounted using the VESA mount that is purchased separately. Ensure to use the correct VESA
specifications as mentioned in the wall-mounting section of the User’s Guide.
For information on safety instructions, see the Safety, Environmental and Regulatory Information (SERI) document that is shipped with
your monitor.
Before working inside your monitor
Steps
1. Save and close all open files and exit all open applications.
2. Turn off your monitor.
3. Disconnect your monitor and all attached devices from their electrical outlets.
4. Disconnect all attached network devices and peripherals, such as keyboard, mouse, and dock from your monitor.
CAUTION: To disconnect a network cable, first unplug the cable from your monitor and then unplug the cable from the
network device.
5. Remove any media card and optical disc from your monitor, if applicable.
After working inside your monitor
CAUTION: Leaving stray or loose screws inside your monitor may severely damage your monitor.
Steps
1. Replace all screws and ensure that no stray screws remain inside your monitor.
2. Connect any external devices, peripherals, or cables you removed before working inside your monitor.
3. Replace any media cards, discs, or any other parts that you removed before working inside your monitor.
4. Connect your monitor and all attached devices to the respective electrical outlets.
5. Turn on your monitor.
To Next Page
Loading...
