Base cover
Removing the base cover
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the microSD card.
3. To remove the base cover:
a. Remove the 9 (M2.5x7.5) screws that secure the base cover to the system.
b. Pry the base cover from the edge using a plastic scribe [1] and lift the base cover from the system [2].
NOTE:
After removing the base cover screws, on-site technicians must take care to remove the base cover
carefully. There are prying recess points next to the left and right hinges which will ease the disassembly procedure.
With the help of a plastic scribe, pry open from the top left side of the base cover, continue working your way
around the left and right side of the base cover, then remove the base cover from the system.
10 Removing and installing components
To Next Page
Loading...
