Installing Input output board
Steps
1. Place the Input output (I/O) board to its slot in the system.
2. Replace the 2 (M2x3) screws to secure the I/O board to the system board.
3. Connect the two I/O cables and close the latch to secure it to the I/O board.
4. Place the I/O bracket and replace the 2 (M2x4) screws to secure the bracket to the system.
5. Install the:
a. battery
b. base cover
c. microSD card
6. Follow the procedure in After working inside your computer.
20
Removing and installing components
To Next Page
Loading...
