3. To remove the camera:
a. Use a plastic scribe to pull the camera out from the chassis [1].
b. Turn the camera [2].
c. Disconnect the camera cable from the connector [3].
d. Lift the camera away from the display assembly.
Installing camera
Steps
1. Connect the camera cable to the connector on the display assembly.
2. Turn the camera and align it to its slot in the display assembly.
3. Install the:
a. display panel-touch
b. display assembly
c. battery
d. base cover
e. microSD card
4. Follow the procedure in After working inside your computer.
Removing and installing components
39
To Next Page
Loading...
