Installing display assembly
Steps
1. Place the chassis on the edge of a plane surface.
2. Align the display assembly with the screw holders on the system.
3. Replace the 6 display hinge bracket screws to secure the display assembly to the system.
4. Lift the system and close the display.
5. Connect the eDP cable to the connector on the system board.
6. Affix the adhesive tape to secure the eDP cable to the system.
7. Place the eDP metal bracket to secure the eDP cable.
8. Replace the single screw to secure the eDP bracket to the system.
9. Connect the following cables:
● EMR cable
● World facing camera cable
● sensor cable
10. Install the:
a. battery
b. base cover
c. microSD card
11. Follow the procedure in After working inside your computer.
32
Removing and installing components
To Next Page
Loading...
