Installing speaker
Steps
1. Place the speakers into the slots on the system.
2. Route the speaker cable through the retention clips in the routing channel.
3. Affix the adhesive tape to secure the speaker cable to the system.
4. Connect the speaker cable to the connector on the system board.
5. Install the:
a. battery
b. base cover
c. microSD card
6. Follow the procedure in After working inside your computer.
WLAN card
Removing WLAN card
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. microSD card
b. base cover
c. battery
3. To remove the WLAN card:
a. Remove the single (M2x3) screw that secures the WLAN card bracket to the system [1].
b. Remove the WLAN card bracket that secures the WLAN antenna cables [2].
c. Disconnect the WLAN antenna cables from the connectors on the WLAN card [3].
d. Slide and lift the WLAN card away from the system [4].
Removing and installing components
17
To Next Page
Loading...
