Installing the battery
Steps
1. Insert the battery into the slot on the system.
2. Replace the 3 (M2x3) screws that secure the battery to the system.
3. Route the battery cable and connect the cable to the connector on the system board.
4. Affix the 2 adhesive tap to secure the cable to the system board.
5. Place the 2 metal brackets to secure the battery cable to its connector on the system board and the battery.
6. Replace the 2 (M2x3) screws, one on each metal bracket, to secure each bracket to the system.
7. Install the:
a. base cover
b. microSD card
8. Follow the procedure in After working inside your computer.
Speaker
Removing speaker
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. microSD card
b. base cover
c. battery
3. To remove the speaker:
a. Disconnect the speaker cable from the connector on the system board [1].
Removing and installing components
15
To Next Page
Loading...
