d. WLAN
3. To remove the system board:
a. Lift the latch and, disconnect the 2 Input/Output cables from the connector on the system board [1].
b. Lift the latch and, disconnect the touchpad cable from the connector on the system board [2].
c. Release the tabs and, disconnect the keyboard cable from the connector on the system board [3].
d. Disconnect speaker cable from the connector on the system board [4].
e. Disconnect the following cables [1]:
● EMR cable
● World facing camera cable
● Sensor board cable
f. Remove the single (M2x4) screw that secures the eDP bracket to the system board [2].
g. Remove the eDP bracket away from the system [3].
h. Peel the adhesive tape that secures the eDP cable to the system board [4].
i. Lift the latch and, disconnect the eDP cable from the connector on the system board [5].
j. Peel the adhesive tape that secures the cable to the system [6].
Removing and installing components
25
To Next Page
Loading...
