c. battery
3. To remove the display assembly:
a. Disconnect the following cables [1]:
● EMR cable
● World facing camera cable
● sensor cable
b. Remove the single (M2x4) screw that secures the eDP bracket to the system board [2].
c. Remove the eDP bracket away from the system [3].
d. Peel the adhesive tape that secures the eDP cable to the system board [4].
e. Lift the latch and, disconnect the eDP cable from the connector on the system board [5].
f. Peel the adhesive tape that secures the cable to the system [6].
g. Turn the system.
30
Removing and installing components
To Next Page
Loading...
