1 heat-sink screws (2) 2 ribbon cable clips (2) 3 release tab
4 card retention mechanism 5 card retention door
5. Use a long Phillips screwdriver to loosen the two captive screws, one on each side of the plastic heat- sink assembly
shield.
CAUTION: The heat-sink assembly may be very hot during normal operation. Be sure that it has had
sufficient time to cool before you touch it.
6. Rotate the heat-sink assembly toward the rear of the computer, and remove it from the computer.
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (50 of 68) [12/9/2007 11:22:24 PM]
To Next Page
Loading...
