1 heat sink and fan shroud assembly 2 captive screw housing (2)
NOTICE: If you are installing a processor upgrade kit from Dell, discard the original heat sink. If you are not installing
a processor upgrade kit from Dell, reuse the original heat sink when you install your new processor.
7. Place your finger upon the hook end of the release lever, then push down and out to release it from the tab that
secures it
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (51 of 68) [12/9/2007 11:22:24 PM]
To Next Page
Loading...
