Dell EMC Core XC750 - Removing the Expansion Card Risers

Table 49. Configuration 9: R2A (continued)
Card type Slot priority Maximum number of cards
Inventec (BOSS 1.5) Integrated slot 1
Removing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system
3. Remove the air shroud or remove the GPU air shroud.
4. If applicable, disconnect the cables from the expansion card or system board.
Steps
1. Loosen the captive screws on the riser.
2. Press the blue release tab or blue button on the riser and holding the edges lift the expansion card riser from the riser
connector on the system board.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 108. Removing the expansion card riser (Riser 1)
Installing and removing system components
111