Dell EMC Core XC750 - Rear Drive Module; Removing the 4 X 2.5-Inch Rear Drive Module

Figure 52. Installing a drive into the drive carrier
Next steps
1. Install the drive carrier.
Rear drive module
Removing the 4 x 2.5-inch rear drive module
Prerequisites
1. If required, Remove the air shroud.
2. Remove the drives.
NOTE:
If the BOSS S2 module is installed, be sure to disconnect the BOSS S2 power cable and signal cable before
removing the 4 x 2.5-inch rear drive module.
3. If installed, Remove the BOSS S2 module.
4. Disconnect the cables from the rear drive module.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws that secures the rear drive module to the system.
2. Lift the rear drive module from the system.
Installing and removing system components
57