Figure 56. Installing the 2 x 2.5-inch rear drive module
Next steps
1. Connect all the cables to the rear drive module.
2. Install the drives.
3. If removed, install the air shroud.
4. Follow the procedure listed in After working inside your system.
Drive backplane
Depending on your system configuration, the drive backplanes supported are listed here:
Table 14. Supported backplane options
System Supported hard drives options
XC Core XC750
2.5-inch (x 8) NVMe backplane
2.5-inch (x 24) SAS, SATA backplane
Figure 57.
Installing and removing system components
61
To Next Page
Loading...
