Figure 73. 24 x 2.5-inch SAS/SATA + 2 x 2.5-inch SAS with expander and fPERC
Table 25. 24 x 2.5-inch SAS/SATA + 2 x 2.5-inch SAS with expander and fPERC
From To
SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
CTRL_SRC_SB1 (fPERC controller connector) DST_SB1 (backplane expander signal connector)
SIG_PWR_2 (system board power connector) BP_PWR_2 (backplane power connector)
SL3_CPU1_PB2 (signal connector on system board) CTRL_DST_PA1 (fPERC input connector)
SIG_PWR_0 (system board power connector) BP_PWR_1 (rear backplane power connector)
SRC_SA1 (backplane expander signal connector) BP_DST_SA1 (rear backplane expander signal connector)
PERC module
Removing the rear mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system
3. Remove the drive backplane cover.
4. If installed, remove the air shroud or remove the GPU air shroud.
5. If required, remove the drive backplane.
6. Disconnect all the cables, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the rear mounting front PERC module.
2. Slide the rear mounting front PERC module to disengage from the connector on the drive backplane.
72
Installing and removing system components
To Next Page
Loading...
